Yamaha control box

[hemidrag]

Hi;
I'm rigging a boat with a 98 yamaha 115. I bought a new set of 703 controls for this motor and find some wires I can not identify. At the bottom of the control is two seperate wire bundles. One has a double yellow wire with female plug, single black with female plug, and single pink with male plug. Other bundle has single yellow female, single green female and single black male. I have the small manual that came with the control and it does not show or mention these. I have the large seloc engine manual which has a section on controls and it is not mentioned there. I assume these are newer style controls as they were just bought but can't seem to find any info. Thanks in advance for any help... Paul

[berg969]

The wires are for gauges in the dash and for an adittional buzzer.
the yellow is key on
the green is tach
the black is ground
the pink is overheat

[hemidrag]

First thank you so much for the quick response. Secound if you don't mind one more question. On the motor (98 115) near the ten pin plug are three other plugs. 1. blue 4pin plug with blue,brown,back,and black red stripe? 2. 4pin plug with two wires, green with black stripe, and green with red stripe?
3. 4pin plug with gray,pink,orange, and black?
Would you know where these go...Thanks again... Paul

[berg969]

plug 1 is power and sender to oil tank
plug 2 is sender for oil level gauge
plug 3 is for trim gauge

[hemidrag]

Again thank you very much, its people like you that make this such a great site.... Paul