PDA

View Full Version : Nitrous question



hosejockey4506
07-05-2007, 12:41 PM
i have a 150 shot wet system sitting in my garage, what would you all say is a moderate shot for a 2.4 bp motor, i would guess 150 is to much if im looking for it to last more than a weekend. :D i was thinking of putting it on the motor but need to order the correct jets

Rusrog
07-05-2007, 12:48 PM
Nitrous puts a heck of a load on a motor but if your rig is fairly light and the motor can spin up, you should be OK. Remember the basis behind nitrous.

You are trying to burn more fuel... Not more nitrous. I've seen guys run 2 100 horse stages with no problems but the system was set-up by an experienced nitrous guy and the systems ran great for years on end.

hosejockey4506
07-05-2007, 01:12 PM
yup i here what your saying this is a wet system with a separate gas nozzle also. the only problem im trying to figure out is how to evenly spray all 6 carbs at once

Hydrophobic guy
07-05-2007, 02:11 PM
Use a fogger on each carb with seperate solinoids on each bank. Keep um gas fat get an assorted jet kit and start small and remember to retard timing and get colder plugs. Make sure you also prop up. Did this on a three cylinder sled. Beat it hard for three years before she lost a piston and sleds generally rev higher. Was fun while it lasted thou.

Jay Smith
07-05-2007, 02:49 PM
No one the planet knows any more about NOS on an outboard than Chuck Goodman @ Nitrox 1 318 965 0201 cst.........

Good luck,

Pro300x24LD
07-05-2007, 03:00 PM
use the old powerhead.....get it right on that one...kinda LOL

johnnyracer
07-05-2007, 04:12 PM
Chuck Goodman !!!!! Period.
Johnny

hosejockey4506
07-06-2007, 07:30 AM
ok thanks for the reference i will get ahold of him when im ready to install