2.5L Crank question..

[TheRickster]

I have a 94 model 200 bare block that I am wating to build up. What is the difference in the later model 850690T2 crankshaft and the older 9536T4 cranks... I am going to use my 2000 model electronics and would like to leave my original O-Ring PH together so I am on a quest to find a crank and rods for the buildup...

Any help again would be appreciated...

Rick

[shawnjetton]

i have a 93 2.5 crank in a 2000 block on my boat right now. dont know the #s on them but it works.

[TheRickster]

So then I would think that in a 94 model block a person could use a 98-2000 model crank and possibly the top cap from the 98 or 2000 as well??

Rick

[shawnjetton]

So then I would think that in a 94 model block a person could use a 98-2000 model crank and possibly the top cap from the 98 or 2000 as well??

Rick
yes, they are the same.

[TheRickster]

So the Top cap follows which style the top bearing is on the crank regardless of the block? Also the center main bearings , which style they are depends solely on the year of the crank and not the block? Sorry for all the specific questions about this swap, I have looked around and could find no answers that were definite yes or no...

Rick

[shawnjetton]

ive used a crank from a 93 in the motor that is on my boat right now which is a 2000 and changed nothing. bottom bearing is same size but i would change it to the steel bearing cage bearing from promarine while its apart. top bearing is also the same. they should be identicle.