Torque tab?

[delawarerick]

Is it ok to epoxy a torque tab on and it goes on the right side with right hand rotation can someone direct me to a previous thread that had a diagram. Thanks Rick

[gotboostedvr6]

rivot it, grind the rivots, smooth it with epoxy

[Carter Powell]

Put epoxy under the tab first then rivet while the epoxy is still wet. It will be there forever.

Carter

[Riverman]

I just did that yesterday. Position and drill first then deburr the holes in the skeg. Mix some epoxy and bed the tab in, then rivet. Use the extra epoxy to fair in the tab. Drink beer and sand the next day! :)

[delawarerick]

Thanks this has been a bad weekend so far. Everybody wants there boats in and we have had a west wind which blows the tide out. Backed down a ramp with a 26 grady and it proceded to try and pull the tractor in. Yesterday we could see 12 we counted them boats on the sandbar. This here is amateur weekend. All be safe. Thanks Rick

[sheuninck]

with two hammers on each side you can cup the skeg