Need thrust washer number for Hydromotive prop

[WATERWINGS]

I tried all the T/W's I had hanging around and they were all to thin.

The prop would hit the bearing carrier.

I need to know what number, (or thickness) that I need for the Hydormotive to fit on a Merc. 200 case/propshaft.

Thanks,

John

[jphii]

Doesn't it have to run before you worry about that:eek::eek:

[WATERWINGS]

Tru Dat........

But it will be the prop to use to break the fresh motor in, and also the prop to use to pull Myriah on the knee board when I do get it broke in. (its a 24)

[WATERWINGS]

Oh............by the way..................

SMART AZZ :eek:

[jphii]

Glad to see ya got one so quick.

[WATERWINGS]

Nope, still got to build one, the parts SHOULD be in tomorrow or so.

[rocket1]

I am running a hydromotive tx4 with merc lower unit on my Allison. Thrust washer part number I use is 13191Q01. Depth is about 1/2 inch thick. Cost at the dealer about $ 15.00. Hope this helps.

[WATERWINGS]

Thanks Rocket,

Is that a Merc. washer, or is it from Hydromotive?

A Hydromotive on an Allison???

I guess I'm not the only one using the "wrong" prop for my tunnel.:eek:

Thanks again,

John

[rocket1]

It is a merc part number...It should work.

[WATERWINGS]

Cool, thanks.