Prop Question

[spanky2002]

IF I AM ABLE TO SPIN A 26 PITCH YAMI DRAG 8000RPM CAN I SPIN A 32 CLEAVER AT LEAST 6600. THE CLEAVER IS A 15 INCH WHEEL WHERE AS THE DRAG IS A 14.5 INCH. IF I CAN'T REACH THESE RPMS SHOULD I PITCH DOWN TO A 30 OR CUT THE 15 DOWN TO A 14.5. THIS SET UP IS DONE WITH A 225 PROMAX AND 2002XB WITH A LIGHT LOAD. THE MOTOR IS STOCK EXCEPT FOR CUT EXHAUST TUNER, REEDS, AND A NON LIMITER COMPUTER. AS YOU CAN SEE I AM LOOKING FOR AS MUCH TOP END AS POSSIBLE. I HAVE A FRIEND WITH MODIFIED 260/BULLET COMBO BUT WILL NOT DRAG WITH ME BUT IS WILLING TO RACE TOP END.

[Jerry Ridenour]

Why ya hung up on a cleaver.i have run drag props cleavers and round ears,and by far the best all around prop is a 28 chopper 2 or 28 mazco.your gonna run within a mile or two of a cleaver and have gobs more acceleration,thats been my experience anyway.

[TODD2002]

yes ,You should be able to turn the 32 to 6600 or proble higher i turn a 30 et to 6750 but it would turn it more if i had a none limiter ecu. I would try a 32 et or chopper 2 if the cleaver didn't give you the numbers that you are looking for.


Todd

[fastbass9]

www.bogerprops.com tell rich your problem and he will fix you right up

[patchesII]

were there any yamaha's that were 15"

[ALLISON7710]

HE PROBALLY HAS A CLONED YAMAHA THAT IS 14.5 LIKE A POWERTECH OR A SODYDAISY CLONE. THEY WORK GREAT.THANKS ERIC.

[spanky2002]

thanks for the info guys. the 15 inch wheel i am talking about is a mazco os. i didn't get to try it yet, i have been working alot of overtime.