New Bezel and Gauges

[PHISH]

I recently bought a full set of Livorsi gauges and angled Bezels. They are going to look sweet! There was a thread on here about installation a few weeks ago but I can't find it.

My question is...When I am putting on the new Bezels and gauges, do I put an adhesive on them to stick them together or to the dash? I remembered someone mentioned that I should be adding clear silicone to the bezels. Is that for the gauge to stick to the bezel or the dash.

I am not worried about hooking the instruments up as they are an exact fit.

If someone could steer me in the right direction that would be great!!

Matt

[PHISH]

I found the thread.
http://forums.screamandfly.com/forums/showthread.php?t=102297&highlight=silicone

Is there any other advise?

[godspeed]

i havent read the thread but ive had very little problems installing them dry (no adheisive) butsilicone sounds like a good idea as long as you use only a dab of it because you and i know it can be messy and silicon finger prints arent fun. good luck

[PHISH]

great, thanks

[axiom]

Hey guys any one know where i Can get my tahiti painted around totonto. You can call me 416-918-2575 Brian

[Jeff "Yammer"]

You do not need any type of glue at all. The guage holds it all in place. The only thing you might have to do is to oval the holes if you are switching from a flat guage placement to the angled bezels ( on some anyway ) Also depending on your dash thickness you may have to make/modify the guage holding brackets ( to compensate for the decreased depth of the guage from the bezel thickness )

Yammer

PS .... Post a few pic's when your done.!!.

[PHISH]

I will definately post before and after pics. Thanks for the tip!