cutting 20 inch to 15

[joed]

who other than eagle one cuts mids? looking quality here

[THE HOGG]

I Think His Name Is Marty Powell?? Ive Read A Lot Of Good Stuff But Dont Have Any Personal Experience.

[mragu]

what is a rough idea of the cost involved if cutting a mid . is it possible to cut a 40hp, 50hp or 70hp merc?

[SUPERBASH]

what is a rough idea of the cost involved if cutting a mid . is it possible to cut a 40hp, 50hp or 70hp merc?

Do you need Joeys # ???http://img523.imageshack.us/img523/6649/bash5ip.gif (http://imageshack.us)

[mragu]

gene, give me a call 516-351-4285

[Ziemer]

If you're looking for quality, buy a real 15" mid. ;)

[Tony Montana]

Marty Powell is the best. He is in St petersburg or CLearwater, FL

[jphii]

Hey Joe, I know Jack Barsh does it, and he does real good work too. It's something like a grand for him to do it, complete, not just hacking the can. Matter of fact, my boat just left his shop this morning. Might have a surprise or 2 for them FBI guys;)

Or you couold do something like in the attached picture, just for ch!ts & grins!

[Corona Mike]

If it's a merc, give Marty Powell a call. He does top quality work on both 2.5 and 3-litre mids. His P.H.# is (727) 524-6286.

[Bruster]

what is a rough idea of the cost involved if cutting a mid . is it possible to cut a 40hp, 50hp or 70hp merc?

Watch eBay, I have several in the last year. Watch for short lower units and ask about the mid!:eek:

I have a short for a '69 35. I don't know if it will work for you.

[PARKER RABE]

have marty powell do it .......trust me u wont be dissapointed , hes the best!!!!!!!!!!! 727 524 6286 or 727 742 1235

[Tom Foley]

Ditto , Marty is the Man !!:D

[Fish]

well, the horse is about dead, but there is a reason so many folks recommend Marty. One more high recomendation for Marty Powell.