- 2" Hydraulic Lift
- Rigging a Skater 28
- Question...Engine hight & nose cone
- Power lift or tilt and trim?
- any suggestions
- Challenger boats of Ontario ?
- Prop suggestions...375lb Checkmate 150hp Merc?
- Mad Efi
- 12ft Boat need steering suggestions
- Prop for Allison XR-2002 with OMC Looper V-4
- 13'4" Clark Craft Homebuilt, where to mount engine???
- Set up for Checkmate 185 Pulse
- Best prop:Checkmate Enchanter/225 PM
- To notch or not to notch?
- Help with setup
- hst
- OMC V8 23' Daytona setup
- What's the story on Suzuki outboards for performance
- Prop suggestions anyone??
- Good "all around" prop for Mirage?
- set up help allison 2001 drag
- 1500 inline weight & jack?
- Hydraulic Jackplate Design
- GlastronCarlson 16 Setup suggestions?
- setup for 200 suzuki on a cmate starflite
- Triton 21 Fish & Ski
- Shadow Porpuse
- dual cable or hydraulic???
- Bronze or Stainless Prop??
- permanent gas tank
- To jackplate or not?
- CMC Wedges
- please humor me--jackplate size for 16'
- Jackplate For 17ft Tracker
- Aluminum Prop
- prop polish
- There are jackplates....
- prop slip
- 1989 vegas xt setup
- Foot Throttles? Shift Levers?
- cable/pulley systems???
- Rigging a checkmate starflite
- set up
- G-3 hp set-up help
- 'Rude & Johnny guys, about models/weights....
- twin outboard v-bottom setup
- Prop for sleekcraft
- what do u think
- drilling exhaust
- transom tie bars/plates
- switzer setups?
- How do you tell a surface riding prop from a buryed prop
- 40 Mariner q's Again....
- Checkmate Mx-13 setups?
- Psi
- prop for vector w/150 merc?
- Temp Probe
- Checkmate 18 setup
- 17' 69 Switzer
- Damn Rsty
- Prop needed;
- Ballistic props any good??
- stroker bass boat
- Rig SetUp
- The Gear
- Dual Steering on a Switzer with V6 Merc
- Hull Extions
- Hydrostream YT
- Sea Star Steering
- prop for 22 velocity
- Promax 300 w/SVS & High Flow Reed Plate - preliminary results
- First jackplate setup question
- 21 ft. Gambler Stallion
- engine height for superboat
- 24 cat w/twin 2.5s rigging help
- new to outboards
- Handling problems
- engine height for true tunnel
- Hydrostream Vector & Merc 200 prop ?
- Twin Promax 300 - how close
- VKing YT placement of pumps
- transom rienf. plates/supports sources?
- Tell me about a Hotfoot
- 150 HP. How fast?
- valero yt ?
- Set-up help for Critchfeild Contender
- Warrantys
- Looking for set-up for 21' checkmate starliner
- 93 186 pulse set up??
- Lots of cavitation /props/ setup help !!
- checkmate setup ???
- Prop advice
- Rapid Jack question.
- chopper VS. cleaver
- what do yall think?
- need better handling
- 1985 Checkmate Enticer/1974 Merc 1500
- scissors jack plate
- 83 checkmate prop help
- learning about and finding a good prop
- Vision Setup help...
- What props fit Yamaha?
- 21 RallySport
- Tempest Plus on Ally 2002xb
- 28 in Hoss Triton 1
- Need Stock Specs for 23p Trophy Plus!!!
- Will 1 Blade Being Off 2 Degrees in Rake Cause Blowout???
- 87 Hydrostream Vegas w/ 175 Mariner-Prop?
- To jackplate or not to jackplate a V-King
- Lets See Ur Mate!!!!
- 1985 12' Baja Scat Cat
- Post your HST Setups and #s
- First Look: My New QuarterMaster Is Back From Paint Shop.
- Steering Pulleys
- Hard To Steer At Speed
- Tell me if I'm out of my mind!
- Low water pickup for Chopper?
- putting more h.p. in a stock 200 merc
- colunm mounted trim and jack controls
- colunm mounted trim and jack controls
- Laser LTV jackplate?
- Hydrosport Spec's And Setup
- Help with prop and setup on MX 15 Checkmate
- Help me with my Allison set up????
- Setup for a gt-150
- Need Prop Help
- violence!!!!!!
- Baja question
- Prop on Drag Allison
- Will a jackplate help?
- Set-up on Bullet
- Sleekcraft Setup
- newbie question, Ebko boat
- OK Dad, Try this
- Gt-160 performance
- Stv River Rocket + 280 Offshore 15" Needs Props?!
- best setup for 21 superboat
- stress cracks
- Merc Cowling Decals
- Custom mods for STV on Sportmaster case?
- dual cable steering???
- 28 Skater dashboards
- Laser 380 Ray setup?
- Rigging help for a 1979 Actioin marine
- 18' Charger DL
- Help Me!!!!
- STV "Hopping problem"??!!Help!
- Is there a prop tweeking book around?
- 10'' setback on a 16' glastron/200 merc???
- set back for 23' bay boat?
- Hub replacement
- Prop Question
- Speed vs Load
- is a vector with a 200 ok??
- AE-21 (HST) prop selection
- 21' setup
- letters stamped on 30 cleaver
- putting a old 3.4 300 merc on a cmate starflite
- Hey Houston Propeller ------->
- Prop Shaft Height?
- Anyone with dual cable steering?
- anybody ever run a 3.4 merc on a cmate starflite?
- prop selection checkmate eluder 175hp
- 4in. spacer
- setback
- Talon T-21
- Hp rating
- 1988 Hydrostream Vision Set up
- stainless steel props better for top end?
- Bass Boat setup question
- Prop Selection for 1983 Champion
- best setup on ventura2 with 150 jonny?
- Merc hub question
- input on steering!
- 2.4 vector
- Motor Height?
- Jack Plate help for bass boat !
- give me your opions please !
- v4 crossflow on 15 viper gps speed
- New Forum Sections Added!
- 225h.o johnson rpms?
- Steckbauer contact info ????
- looking for more speed
- painting the bottom of the boat
- Cowl Paint Jobs
- I know I have asked this before...
- 15 inch midsections
- Latham vs. Mayfair steering
- Meshing a Bullet with 250XS
- It runs!!
- Prop
- Steering Cables
- Gas Tank
- Trim Clyinder
- Torque-shift? Prop help?
- Best Prop For Allison Xr-2002
- 1987 stratus 169V setup help
- Set up questions.....
- What does a Laser 380 Ray weigh?
- Transom mounted water pick ups.
- 2.4 hood pin bracket
- Engine guages
- My Evinrude 225 setup
- help me set up my new 82 v-king
- quartermaster set up?
- Setback rules
- 88 V-King and 115 Merc setup.
- Set up
- All you gurus
- Twin Merc Setup
- Anyone race against twin Merc cats/tunnels?
- all you gurus
- Need a Merc 280 Offshore 15"........
- Hydraulic jack plates?? yes / no
- Superboat setup
- bad setup with early 70 boat.
- Laser ????????????????????
- OMC Raker question
- Chopper Props
- Treatment of bottom pad.
- Prop help
- allison owners
- any one got a hot setup for GW
- 21'Skater/260 EFI or 280 HELP !
- storing boat in winter safely
- 93 Johnson200GT Hop-Ups
- low rpm 2.5 efi offshore 260 hp
- Try Out Our New Classifieds!
- Do Those Enlarged Cavitation Plates(bolt ons) Help Holeshot?
- Am I Maxed Out?
- Bow lift
- Which Prop For 1/4 Mile
- Mounting Engine-Correct Height
- Voo-doo Questions!!
- 15'allison set up........?
- 379 javelin set up
- Suzuli 2-stroke prop on OMC V4
- What ski prop to use on an HST?
- need more speed
- how do i turn the rev. limt up
- small hp cleaver
- 2001RR setup
- Greg or Redbullet help!
- 17 action fuel tank where to put?
- New Forum: Audio Systems, Electronics, Gauges, and Wiring
- Boat Insurance for Cats?Help?
- Power Tech Props??
- re-hubbing Renegade prop
- Prop for Mako CC
- Brucato Pcu