Activity Stream

Yes, I still enjoy my coffee with Billy every morning....:)

John Hill - McEwans/Burgess/Evinrude CC UIM OE class 1980 (Pretty sure its from Paris same year) Paris 6 Hours 1980..finally in the winners...

Two Stroke, your observation is in line with a piece of info I received yesterday. A Yamaha Master Tech was kind enough to spend a few minutes...

Joe! I am glad you have chosen to weigh in on this discussion! I say this because I know that you know high performance recreational boating as well...

Cobra Poster Girl “Billy” at the 1985 IMTEC Show While the Cobra Stern Drive is long gone, memories of Billy’s Cobra posters seem to live on....

We have been running a 3.4 with a sportmaster on it for 3 trouble free years. Yes it has a hydraulic plate, yes we added solid mounts, yes we run...

It is stainless steel, not magnetic so 300 series. This one was separated from the set which was sold years ago.... can't remember who bought them.

Sounds like a it might be a good idea to take the plate to a good welder. Have the worn area filled. The weld is usually harder then the base...

Is that new regulator or the old one? Pissing out vacuum hose? Any way I'm pretty sure there are two nipples on plenum box. One is a vacuum leading...

Just discovered the nut on the positive post on the fuel pump is spinning. Thread must be stripped.

well,well,well. got it running pulled off the vacuum hose to reg & raw fuel pumping out? that hose is T into an bleed line. always been ro firtsuted...

from what i remember the seams were not spot welded on the factory stuff. A continuous long bead weld. And its hard to tell but the factory stuff...

That motor has had a long history of use in salt and adapter plate/driveshaft housing issues. Appears to have been replaced/worked on twice under...

Trae Appling

the reason for the relay is because back when people ran 260's powering the fuel pump from the key harness the draw from the pump exceeded the little...

Carter, I talked to Mag machine about two weeks ago and he told me that he charges $1600 as long as all the sleeves are ok and he doesn't have to do...