Activity Stream

your first post, u raised the motor 1'' more, and more slip w/ cone. why not put it back where it was before the cone? with the low slip #s?

I've had reeds that lasted a long time,but 30 years might be pushing your luck,no idea who made em?

ya so I brought the arm to two machinists today and one said was too big for his lathe or his tool couldn’t slide over far enough, the other said he...

we'll jus hafta disagree.. never seen one that didn't show "any" under water exhaust discharge on idle......... never seen a idle relief (tha older...

i respectfully disagree, i have 2 pmax,s, at idle, neither exit exhaust under water. btw my 24 exits thru thr eybrows, above the water..

What are you looking for casting number?

the issue is the 3 ram and single trim arms are not a direct swap, u can use any 3 ram arm, skinny, fat, older, newer stainless, rusted etc haha in...

depends on adapter plate and/or plates.. pisser from each head?... looks like it?... either way exhaust should be comin' from both below water...

my money is on a abby-normal port motor..

All this talk about measuring… When I swapped the skinny tiller out of my 1987 three-ram, for a fat tiller back into the same three-ram, I didn’t...

Put it on the trailer and start investigating. Fresh or saltwater? Maybe something rotted away.

Yep that was me, except for the pedal.

OK Good glad u doubled checked the measurements, I will get back here once I have it milled down, seems a lot easier than drilling it out and or...

Any pictures?

Well while we're at it the next one is what to rename Beer , Thinking Fluid , Decision Juice , Epiphany Elixir , ? feel free I'm sure I missed a few...

if those are high perf mids tha down housing will be drilled and no can... should exit tha same.. tha port seems normal.. at idle heavier pee...

my 25 doesnt bubble up like your port motor at idle. exits out of the mid,above the water. the port motor seems weird to me, other seems normal IMO...

Welcome to the site. Can't say as I have ever seen anything like that. Has to be going somewhere. Rock

Here is a few more pics! I erased your phone/text number some how. Here is my number if you want more pics send me a text. Talk to you soon..

Rich...Stuck injector,bad o ring in efi front,bad tps,plugged screen in regulator,no spark on one or more cylinders,low low compression one or more...

early laser?.. could be injectors and tpi........ never had both bad at same time but can see where that could happen and cause a way bad situation.....

never seen that before :confused:... had tuners fall off and made it exit funny but never completely gone???

What do the plugs look like ? Sounds like it's rich

Is that is the one piece cowl that still uses the eyebrows for exhaust relief? If it is I think I have a set in black from a Merc 200. Same cowl,...

Yep, 100% :( As I said back in post #20 of this thread we had them in Australia until mid-2020 when the Feds slammed the door on further sales of...