Activity Stream

RJ - What was the attraction for OMC to show up with all their rotary power at Provo (of all places?) ??? Was Mercury there? Was this the last...

Could be the rev limiter is set lower than you think. You can either send the ACU back to Brucato to have them check and adjust the rev limiter if...

you've never worked an M2 jet drive in a bombadier, i"ll take an outboard any day!

Happy birthday to your friend :)

The cover nut is under the water pump base. It was '86 when the alpha drive came out. It was the same time the cover nut driveshaft units came out....

Sorry Kirch. I have never seen a case with no nut and no pin. Unless the pin is broken. I cant help you with that one. Anyone else ever seen a case...

Happy birthday to your friend. Even a bad day out on a boat is still a good day. As long as you make it home safely.

Your motor will melt long before the exhaust melts the prop hub. The leak in the exhaut devider has nothing to do with it either. But you do need to...

ski, i see shafts with no nut under the bearing, pre-load style, but no pin.. what is that shaft?

As long as the shaft has the pin it should work. All the V6 cases will fit. Preload or no preload doesn't matter. I had a preload case from a 1981...

Could be John

Maybe Kathy can chime in, but I thought this was the second boat. The zebra stripes were added later.

as long as it has the pin.,itl be good to go? that case shifted always shifted like Butter, quiet too,,

We just left Aruba. It is still beautiful but it is so much more commercialized. It is so much more devoloped. There is so much more traffic it...

The count will keep going up,even if he does die.

Jimbo & Bob Nagode both worked in their shop located inside the former OMC boat plant. While Bob was the wood worker, he & Jimbo designed & built...

Ski , we were typing at the same time. LOL

I hope Rock has one for you. You definitely can not interchange shafts. The reason why the no pin has a nut under pump is because the gear design...

If the original shaft has a pin, the new shaft has to have a pin also or it will distroy itself almost immediately. A preload case uses the pin to...

Pretty sure you will need the pin. Units with out the pin have a nut holding the bearing in place under the water pump. I may have one with pin. I'll...

Welcome to the board! I've had trouble with press in hubs also, I think it's the nature of the beast. I've passed on buying a couple nice wheels...