Activity Stream

In post# 13009 ….Are these motors the first generation of the Johnson Stinger Scorpion race engines? Circa 1971? How much horsepower would they...

nng That old OMC mid deserves to have some dignity in its final resting place. I have a Merc 950 SS and a 1957 Johnson 18 HP proudly perched on...

Remind me what your government has done for us (all of us) I think, had they done their job no one would be unhappy.

Are you running the stock air box for your carbs

Missed you Joe and Greg Terzian !

Great times ! Thanks to all who showed up for the run and party at the house, it was a blast ! We look forward to the next one in November! Post...

You’ll never get a dimocrat to agree with that.

The "four stroke money" argument doesn't hold up. In 2018, the last year of Mecr's 2 strokes, the basic 2018 300XS listed for $24,349.(Standard mid,...

Funny, I expected to see a picture of you Cuda. You're the poster child for TDS! ��

Sounds just like a v6 merc with bleed hoses, flooded from puddled fuel in front of the reeds. I’m no expert and don’t know the sure fire cure but I...

Had the last government done any of what they were overly paid to do, we ALL would not be in this predicament! :nonod:

First thing I would check would be your fuel pressure to see if it’s too high. I had a badass Monty-built 3.0L looper back in the late 90s that was...

We need a way to unlike a post to start with. I just realized there are commies here.

I couldn’t care less what Germany thinks. I worked for a german company for a short time due to a buyout. They think they’re the smartest people on...

PM sent.

I know, I have been in his shoes before waiting on the new ride. It is painful. I can't wait to check out his new boat. Great boat for the...

107 full of fuel in 90 degree air. I am waiting on a prop, it’s into the rev limiter. And then merc ecu starts pulling power out @6200 rpm and I am...

Start by pushing in the key as it tries to stall, if that helps you need to richen your idle mixture

So advertising a vehicle for $40,000 gets deposits and the lowest price is $70,000. is just fine with You ? Charging people over $10,000 for...

Did you get rid of your parts?

I haven’t had a chance to test the boat recently, but I’ve made a few changes to the fuel system that I’m hoping will cure the fuel pressure drop...

Did not click link as I suggest everyone else should not either but the dribble you have written is the Democrats of today's problem in a nutshell....

didn't the omc case have the shim thickness installed stamped into the housing at factory assembly stage! you might want to check crowley...