Activity Stream

I just got back a couple hrs ago from running my personal best mph. Made 80.73 out of the little 150hp.

If my mind serves me...you would hook the two yellow/red together at the shift box to bypass neutral safety. Something like that anyhow.

you should be able ta run it at 2/3 grand or more for what ever amount of time you think is ok.. if there's gonna be a problem it will be at idle and...

If I were going to start in gear how do I bypass nuetral switch? I do have a foot throttle so I can kinda manipulate it separate if shifting gears. ...

Fishing junk is set at like 650rpm in gear. I don't have nothing with a horn, but I think most guys bump it up a bit. Depends if you want to start...

Also any reccomendation on idle rpm? Wondering if I need to adjust the throttle linkage to raise it slightly or if it’s just loaded up from running...

Yeah just plug off as much flow out of the poppet as possible. Maybe not all, but most.

Carrier is 65848, came in the poppet rebuild kit mentioned a few pages back. There is nothing in the block, this motor does not typically use a...

thats something i've never ran across that i remember!.. as a mater of fact i don't remember ever adding a poppet ta any hi perf. motor i've had.....

you won't find a BP with a "factory" poppet.. they only came on one piece plates.. even with tha bass can..

Holy smokes! But I guess that is what happens when you have a monopoly on parts. Did that stub shaft come with Vaseline?

Do you guys have a part # for the pieces that don't fit? The only cross compatable part numbers between the old poppet design, and new, is the...

Sent

Perfect for that .......... problem solved https://www.screamandfly.com/showthread.php?368014-22-Velocity-OB

I couldn't figure out how to attach a picture to the PM section. Michial sent me a PM a couple months ago, I almost never read them. Took her out...

I could be wrong but it looks to me like the old carrier is still in the block but does not have the seal on it. I don't change the carrier unless it...

It doesn’t seem close enough size wise but I don’t have a good way to measure the hole in the block at home to confirm unfortunately. It would be a...

Back to the top.

No funds sent, no reply from buyer. Buyer flaked! Such a waste of time. Back up for sale. Some of the newer members on Scream and Fly are not...

i've had ta actually "drive" tha grommet in (still staked it after tha fact) with a socket and extension (extension inserted in tha socket backwards,...

Mine is ready to go minus the popper carrier issue. mine did show 3-4psi water pressure with hose half way on and I know I was getting flow up...

Stoning?

I have exact same issue no part to seal at the engine block. Ordered same part and doesn’t fit. With just poppet I had no pressure either.hope...

I'm curious how much the outboard will weigh at the end.

Hey, not familiar with CLE- have an 86 Mariner 150 20" and it has a tourqemaster- will this fit that year? Thanks

That's an awesome ride you have there. Thanks for the up date

If this poppet situation isn’t gonna work can I restrict anything temporarily so I can run it tomorrow without hurting it? Ran it on the hose...

Yess I appreciate it pooljunkie57@yahoo.com