Activity Stream

I've tore down a few motors but I'm no expert. What finish is ideal on the crank journals? Mirror brite or something a little rougher to make sure...

For what started back in the early 1920’s and ran until the late 1960’s Albany to 72nd street NY Marathon. I have decided to make an Endurance Run...

"The Lamborghini Yacht, officially known as the Tecnomar for Lamborghini 63, is manufactured by The Italian Sea Group's Tecnomar brand. This...

I have a 1986 225hp Evinrude e225txcda trying to make sense of the part numbers for the cylinder heads boats.net has two part numbers for this...

Hello Scream and Fly Members, a sort time ago Nizpro Marine decided it was well time to become both a Supporting Vendor and Forum member of your...

This appeared on Facebook Marketplace. It's pretty close to me so I contacted the owner because I must get a closer look at this. It's so...

Anybody else get this every once and a while?

I recently picked up a 30p big ear small shaft chopper. I wonder why it’s built so different than all the other big ear choppers? For starters it’s a...

Starts and runs fine. Takes off great, runs about 100 yards and starts slowing down like it’s running out of gas. Doesn’t miss or die. Let it idle a...

My friend inherited a fishing boat that hasn’t been on the water since 2018 and I offered to help him get it going. Outboard is a 1998 3 cylinder...

at did sometempting to put my 2.5 back together after machine work. question do i use sealer on the case halfs? also best position for block when...

Keep in mind I'm a novice and have done water pump and carb rebuilds at the most on my 1990's Mercury 20 - stroke. I've got a line on a 1970's -...

Jeff and Lee continue to outdo themselves, and it's easy to see why the Trick 23 Widebody is getting so much attention!

I'm rebuidling a 200 2.5 EFI outboard. 2000ish year. It has the O ring head. I have the remains of a 175 mercury sport jet. I was told that...

https://www.msnbc.com/msnbc/watch/gov-newsom-tells-president-trump-to-stand-down-amid-l-a-protests-241152581707

Steel sleeve 2.5 poppet and washers, 2 piece plate I put in a factory head temp sender and guage over winter and i started chasing the phantom over...

It all made perfect sense. I broke it down into two points, maintenance, and prop selection. Maintenance should be a given, or at least should not...

Axios Musk goes nuclear: "Without me, Trump would have lost the election" Elon Musk declared all-out war on President Trump Thursday, writing...

hmm , seem others feel the same way https://www.youtube.com/watch?v=Ze1lKYjRIR0:nonod:

I want to build a 7 petal 2.5 with carbs. What carbs and jet sizes should I use? what would I have to do to a 200 block to get 245 hp like the carb...

Mike Bethan - Pilot Sean Lanier - Spotter/Navigator

I went out this morning and within ten minutes my 260 started running bad. I pulled spark plugs and I had two NGK BPZ8HS 10 plugs and it appears...

A Friend of mine attempted to change his water pump on a Merc 4-stroke 115hp after the dealer told him 8 weeks before he could take it. Well...

some chatter about Yacht's lately , This is a proper Yacht I don't care who you are , I can see sitting on the stern Salon in the evening down...

Right hand 2.5 mercury 20inch torque master lower unit $1300 obo photos soon

It's been a long time so I apologize if I'm posting in the wrong area. I searched all over and still haven't found a clear answer. I recently...

I think �� that we have a new Scammer on the want to buy Page's again. The "new member" has zero posts, zero likes, zero quotes, all zeros on his...