User Tag List
Results 1 to 15 of 42
-
10-08-2017, 02:58 PM #16000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Two Mercury 300X Motors Available-LH & RH 1.62:1 Sport Masters-Fresh Water Only!!
I have 2 fresh water Mercury 300X motors for sale. My Cougar 22MTR has been sold and delivered to the new owner and my new 22MTR already has 2-300Xs on it, so I don't need these engines.
The first one is a 2003 Mercury 300X that was one me previous 22MTR that Euroski now owns. It has only 134 total hours and with only 3.3 hours on a fresh rebuild which included sleeves in #1 and #2. The other cylinders were checked and were with-in spec. All new Mercury rings, bearings, seals and gaskets were used in the re-assembly (receipts available). There was a small hole (size of a quarter) in the front half that has been professionally welded. It is still in the break-in mode. I had the injectors cleaned and flowed as well. The motor has a 1.62:1 Sport Master gear case that has the billet drive shaft seal and the double seal shift shaft conversion. The motor also has the 20" heavy duty offshore mid section with the single ram trim and the boat mounted trim pump and oil tank (both included). The cowl is in good condition but the decals are pealing in places, which is an easy fix. I have owned the motor since 53 hours. The motor was re-built due to a premature lower main crank bearing failure. If you are looking for an upgrade to your current power, this is the one. I am asking $11,500 US and I will consider serious offers.
Compression Numbers: #1-130 #2-140 #3-130 #4-130 #5-140 #6-140. With only 4 hours since the rebuild, I don't believe the rings have been fully seated in.
The photos show the leak down numbers and the run history on the motor since the rebuild and the total hours. I will post the info on the other motor separately.
Thanks
GaryLast edited by Hydrogasm; 12-06-2017 at 03:25 PM. Reason: Added info!
-
10-08-2017, 04:02 PM #26000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Two Mercury 300X Motors Available-LH & RH 1.62:1 Sport Masters-Fresh Water Only!!
The second motor is the motor that came on my last Cougar 22MTR. It is a 2004 300X with only 87.7 total hours and only 11.4 hours on a factory long block that was replaced by Mercury under warranty (receipt available) due to a premature crank shaft failure. The motor also has a 20" Offshore mid as well. The motor includes the trim pump and oil tank. For anyone that is interested in doing twins on their boat like I was originally planning to do, the motor can also be bought with a LH 1.62:1 Sport Master gear case, that was rebuilt with all new bearing and seals including Todd's billet drive shaft and shift shaft seal pieces. It has 0 hours since being rebuilt and all Mercury parts were used in the re-assembly. This motor is in great condition as well. I am asking $13,500 US for the motor. Let me know if you have any questions. The best way to reach me is by e-mail at garyeisnor@eastlink.ca
Thanks
GaryLast edited by Hydrogasm; 10-15-2017 at 08:01 PM. Reason: added more photos
-
10-08-2017, 04:13 PM #36000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Two Mercury 300X Motors Available-LH & RH 1.62:1 Sport Masters-Fresh Water Only!!
For anyone that is interested in both motors to do twins on a boat, I have a pair of Latham wing plates, a pair of SeaStar HC6345 cylinders and a SeaStar Pro Sport Tilt Helm available separately as well.
Thanks
Gary
-
10-09-2017, 09:43 AM #46000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Two Mercury 300X Motors Available-LH & RH 1.62:1 Sport Masters-Fresh Water Only!!
Both motors are available separately and the first buyer gets to choose which engine and gear case they want. I can build crates and ship them as well. The last 300X that I sold when crated was 6' x 4' x 2' weighing about 700lbs. I can ship it from my work in Coldbrook, Nova Scotia, B4R 1A2 and we have a fork lift to load it. Please e-mail me with any questions at garyeisnor@eastlink.ca
Thanks
GaryLast edited by Hydrogasm; 01-10-2018 at 09:41 PM.
-
10-11-2017, 01:23 PM #56000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
-
10-14-2017, 09:35 PM #66000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Two Mercury 300X Motors Available-LH & RH 1.62:1 Sport Masters-Fresh Water Only!!
Buyer never showed up, so both motors are still available. E-mail me directly at garyeisnor@eastlink.ca with any questions or offers on either or both engines.
Thanks
GaryLast edited by Hydrogasm; 10-15-2017 at 11:00 AM. Reason: Spelling!
-
10-19-2017, 11:39 AM #76000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Two Mercury 300X Motors Available-LH & RH 1.62:1 Sport Masters-Fresh Water Only!!
Lots of interest in the motors but they are both still available. E-mail me directly at garyeisnor@eastlink.ca with any questions or offers.
Thanks
Gary
-
10-25-2017, 09:51 PM #86000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Two Mercury 300X Motors Available-LH & RH 1.62:1 Sport Masters-Fresh Water Only!!
Over 1,100 views but both motors are still available. Someone must be looking to re-power their boat over the winter. Let's hear some serious offers at garyeisnor@eastlink.ca
Thanks
GaryLast edited by Hydrogasm; 10-25-2017 at 09:52 PM. Reason: Spelling!
-
seychellesboy liked this post
-
10-26-2017, 10:51 AM #96000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Two Mercury 300X Motors Available-LH & RH 1.62:1 Sport Masters-Fresh Water Only!!
I am hoping to pick up my new boat on Nov 18th in Madison, Wisconsin, weather permitting and I will be travelling through the states from Maine, so I may be able to help with delivery if a buyer wanted to meet me along the way for either motor. E-mail me directly at garyeisnor@eastlink.ca to discuss possible options.
Thanks
GaryLast edited by Hydrogasm; 10-26-2017 at 09:52 PM. Reason: Location change
-
11-01-2017, 06:02 PM #106000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Two Mercury 300X Motors Available-LH & RH 1.62:1 Sport Masters-Fresh Water Only!!
Still lots of inquiries but no one has pulled the trigger yet. As I said above, I may be able to help with delivery along my way to pick up my new boat. E-mail me directly at garyeisnor@eastlink.ca with any questions or offers.
Thanks
Gary
-
11-02-2017, 09:18 PM #11Junior Member
- Join Date
- Aug 2017
- Location
- Mississauga, Ontario Canada
- Posts
- 10
- Thanks (Given)
- 3
- Thanks (Received)
- 1
- Likes (Given)
- 3
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
You're rollin' just about right past me on your way to pickup your rig! Wish I was in a position to make an offer at this point.
GLWS!
-
11-02-2017, 09:51 PM #126000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Two Mercury 300X Motors Available-LH & RH 1.62:1 Sport Masters-Fresh Water Only!!
Droozki
I was planning on travelling through the US to Wisconsin but I can change my route if you can come up with the funds. You have a few days to see what you can do. E-mail me directly at garyeisnor@eastlink.ca with your contact number and let's see what we can come up with.
Thanks
Gary
-
11-02-2017, 10:12 PM #13Junior Member
- Join Date
- Aug 2017
- Location
- Mississauga, Ontario Canada
- Posts
- 10
- Thanks (Given)
- 3
- Thanks (Received)
- 1
- Likes (Given)
- 3
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Gary, I'd hafta sell a couple of bikes first, and from my experience, that's not likely to happen in the next few days.
However, should the unlikely happen, I have your email addy.
Droozki
-
11-04-2017, 04:56 PM #14New Member
- Join Date
- Apr 2010
- Location
- Warwick RI
- Posts
- 2
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
sent you an email Gary.... hopefully we can work something out.
-
11-04-2017, 05:34 PM #156000 RPM
- Join Date
- Apr 2001
- Location
- Aylesford Lake,NS Can.
- Posts
- 1,728
- Thanks (Given)
- 6
- Thanks (Received)
- 34
- Likes (Given)
- 2
- Likes (Received)
- 152
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Similar Threads
-
28' Skater Tripple Drag motors, Fresh water $65K
By noli in forum Ebay Listings and Other Internet ListingsReplies: 29Last Post: 04-13-2016, 11:31 AM -
Mercury Outboards EFI Sport Masters
By Smoke in forum Outboard EnginesReplies: 1Last Post: 04-28-2015, 06:43 PM