User Tag List

Thanks Thanks:  0
Likes Likes:  0
Results 1 to 5 of 5
  1. #1
    Join Date
    Nov 2004
    Location
    LEBANON OREGON
    Posts
    7,077
    Thanks (Given)
    1
    Thanks (Received)
    2
    Likes (Given)
    23
    Likes (Received)
    11
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    200 opti sport jet losses rpm after 6-10 seconds

    at WOT gets 5700 rpm for 6-7 seconds then drops to 5000

    cleaned injectors
    new reeds
    gone thru compressor
    checked tracer valve, regulators etc
    fuel pressure 95/105
    air pressure dead headed 128 psi
    cleaned air injectors fuel injectors replaced 1 cyl that tested low flow
    fuel pumps test good

    has spark on all 6
    swapped crank sensor with known good

    can cyl drop test at speed no effect on cyl 5 or 6 above 3500 rpm exept within first attempt at WOT where its holding 5700 before it falls to 5k


    cyl 6 has the new set of injectors and has been issue since beginning..



    missing something seems sensor or electrical as mechanicals are sound running out of ideas here

    4-16-2014. 25 years old today... the fishin boat doesnt look to bad for a classic does she


    things that were are no longer as they are today...

  2. #2
    Join Date
    May 2001
    Location
    Ga
    Posts
    1,788
    Thanks (Given)
    1
    Thanks (Received)
    28
    Likes (Given)
    22
    Likes (Received)
    216
    Mentioned
    1 Post(s)
    Tagged
    0 Thread(s)
    I'd try a coil on # 5 or 6 . Also take a good look at the 5 pin where the harness plugs into the coil. We have seen them melt together there. If you have a temp gun ,I like to check the coil temps ,it's a good way to see if anyone is dead . Are you looking at air and fuel psi at wot ? Have you looked into the jet pump stator veins and impeller ? Make sure the shift gate is not dropping down a little at wot . hf ...

  3. #3
    Join Date
    Feb 2005
    Location
    seattle
    Posts
    2,654
    Thanks (Given)
    0
    Thanks (Received)
    17
    Likes (Given)
    0
    Likes (Received)
    33
    Mentioned
    2 Post(s)
    Tagged
    0 Thread(s)
    change the plugs next. they can some times act erroric[sp] under pressure. been there.

  4. #4
    Join Date
    Aug 2007
    Location
    Ft. Lauderdale, Fl
    Posts
    12,397
    Thanks (Given)
    13
    Thanks (Received)
    342
    Likes (Given)
    18
    Likes (Received)
    2872
    Mentioned
    1 Post(s)
    Tagged
    0 Thread(s)
    Fuel vent clogged or fuel restriction of some kind maybe. Put a vacuum gauge inline where the fuel line hooks up to the engine. more than 3 - 4 inches of vacuum will make it starve.
    "One of the penalties for refusing to participate in politics is that you end up being governed by your inferiors". Plato .

  5. #5
    Join Date
    Feb 2014
    Location
    Missouri
    Posts
    1,212
    Thanks (Given)
    2
    Thanks (Received)
    66
    Likes (Given)
    12
    Likes (Received)
    83
    Mentioned
    1 Post(s)
    Tagged
    0 Thread(s)
    Check the map sensor/load sensor. A issue with one cylinder can through the reading erratic. Or tap test it to see if the piezoelectric board broke.

    stuck float in the vst? If you were carb I would say it’s acting like over rich idle loading up the crankcase. Then burning it off for a second when the hammers down.

    Another option is cavitation water falsely boosting rpm then your planed off lift and gain clean flow. Is their a noticeable speed change when rpm drop.
    Last edited by Motv18; 03-20-2018 at 08:19 AM.

Similar Threads

  1. Evinrude 225 HO Should I cut my losses
    By Stratos_Kid in forum Technical Discussion
    Replies: 29
    Last Post: 12-02-2015, 12:27 PM
  2. Looking for20 inch Sport master Lower Unit RH mercury Opti Max
    By ekaterina in forum General Boating Discussion
    Replies: 0
    Last Post: 09-24-2012, 10:00 AM
  3. Obama Losses a vote!
    By The Big Al in forum The Scream And Fly Lounge
    Replies: 4
    Last Post: 10-14-2008, 06:02 PM
  4. 225 Opti Sport XS Fuel consumption
    By stingray240cs in forum Four Stroke and Direct Injected Two Stroke Engines
    Replies: 5
    Last Post: 04-30-2007, 10:21 AM
  5. Wins and Losses using an EGT?
    By Johan in forum Technical Discussion
    Replies: 4
    Last Post: 02-28-2002, 10:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •