Cast Alum welding?

[Tom Foley]

Tons of great used machines out there . I still have and use daily my 1986 Synchrowave 300 along with 3- Sync 351's and a Sync 250 . All work great for steel and aluminum . All require a 90 - 100 amp breaker for full power . I have also had a Dynasty that we used for low input amp mobile work . Get a good used 250 and you are set for life . I like the extra power of the 351 for heavy work such as engine brackets etc . Pic shows what we build and weld , lots of welding !!

[brussrude]

I'm using an Lincoln square wave tig 255 with water cooled torch. Bought it new 15 years ago and still works for me...

[bullet20vee]

Tons of great used machines out there . I still have and use daily my 1986 Synchrowave 300 along with 3- Sync 351's and a Sync 250 . All work great for steel and aluminum . All require a 90 - 100 amp breaker for full power . I have also had a Dynasty that we used for low input amp mobile work . Get a good used 250 and you are set for life . I like the extra power of the 351 for heavy work such as engine brackets etc . Pic shows what we build and weld , lots of welding !!

What kind of bender do you use? I have a Mittler bros that I use for bending handrails and such, but it is somewhet limited due to the radius of the dies. Been looking at a couple of mandrel types.

[H2OPERF]

Tom do u guys make water tanks , I need to have one made for my stv ,i want one V shaped baffle in the back that i would like to put 2 trap doors in and need a #10 an bung lower back and 2 #10 an bungs on top I already have a bolt on cap and the an bungs was gonna make it myself but this boat will will never get done if dont get some stuff made. i was told i need a water tank because the pick up is on the botom back ,I dont want a tube i want to draw from the lowest point. Dave