Stratos ASX help

[Fishingguide]

I recently purchased a Stratos ASX with an 03 225 Evinrude ho on it. Currently it runs 71 mph at 5800 RPMs at 2.25 in below the pad with a 27 tempest . The motor has been fresh rebuilt and compression is prefect, I know this boat is capable of much more but I'm not sure where to start on setup. Any help you guys could give me would be greatly appreciated, thanks.

[ccuboy123]

I recently purchased a Stratos ASX with an 03 225 Evinrude ho on it. Currently it runs 71 mph at 5800 RPMs at 2.25 in below the pad with a 27 tempest . The motor has been fresh rebuilt and compression is prefect, I know this boat is capable of much more but I'm not sure where to start on setup. Any help you guys could give me would be greatly appreciated, thanks.

Raise till you lose pressure
txp prop super good and fast with that motor
shouls be a 80 plus rig easy

[Blue27]

I recently purchased a Stratos ASX with an 03 225 Evinrude ho on it. Currently it runs 71 mph at 5800 RPMs at 2.25 in below the pad with a 27 tempest . The motor has been fresh rebuilt and compression is prefect, I know this boat is capable of much more but I'm not sure where to start on setup. Any help you guys could give me would be greatly appreciated, thanks.

I had the same set up. I ran a 28 Raker with the propshaft 1.5 inches below the bottom I would run right at 6000rpm and 80mph. Watch your water pressure. At that set up I was right on the edge of overheat. After a nose job I felt better having good pressure.

[Fishingguide]

Were you running the lightning lower unit before the nose cone? That's what I have on mine right now.

[Blue27]

Were you running the lightning lower unit before the nose cone? That's what I have on mine right now.

I was running the lightning. Nose inlets didn't get me any speed just less nervous running that high. I was always worried about low water pressure.