merc 2,5 efi gearbox water intake. Is it right done.

[lassedomir]

Hello.
Is the the right way its done for low water pickup ekstra on my Hydrolift 22" please see picture

On my pyrometer its not the same tempature on the exhaust and when its runs 1000 rpm
there is missing water on this side. At 2000 rpm its ok but not a nice flow.

Thanks for reading and helping.

Kindly Lasse

[eli]

your plumbed right into water pump thats fine pickups under bullet plugged

[lassedomir]

I tried to put a water hose on but there was no water out through the engine even though there was full pressure on water from the faucet. It's like the same water pressure does not come out of the 2 holes from the engine at idle. Could it be due to the "extra low water intake"?Regards Lasse and thanks in advance
I tried to put a water hose on but there was no water out through the engine even though there was full pressure on water from the faucet. It's like the same water pressure does not come out of the 2 holes from the engine at idle. Could it be due to the "extra low water intake"?Regards Lasse and thanks in advance

[eli]

take off side cover see if there anything plugged where you have hose going in,even on the hose you will have plenty water it wont show much pressure on a gauge