User Tag List
Results 1 to 2 of 2
-
08-23-2017, 12:03 PM #1Junior Member
- Join Date
- May 2017
- Location
- florida
- Posts
- 22
- Thanks (Given)
- 0
- Thanks (Received)
- 1
- Likes (Given)
- 0
- Likes (Received)
- 1
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
thru to over the hub exhaust..do I adjust pitch?
Does some type of baseline exist when going from a thru hub exhaust to an over the hub like a cleaver or chopper? I know the charicteristics of each but it seems between exhaust flowing over and surfacing the prop I would need more pitch.
Do we have rule of thumb? I am running a 10x13 through hub stainless at my target 5500 rpm. 3 inch setback 2 inch over standard.
-
phillnjack thanked for this postphillnjack liked this post
-
08-24-2017, 07:20 AM #2Screaming And Flying!
- Join Date
- Mar 2008
- Location
- Tourist Trap, Florida
- Posts
- 14,753
- Thanks (Given)
- 381
- Thanks (Received)
- 1305
- Likes (Given)
- 5602
- Likes (Received)
- 11033
- Mentioned
- 2 Post(s)
- Tagged
- 1 Thread(s)
Often the over the blade props have more blade area and no change in pitch is needed. I am guessing that this is a low hp motor due to the 10x13 prop size. It really is a trial and error thing as you change to a OTH prop you generally start raising the motor height to surface it. When surfacing a prop it will usually turn a few hundred more rpm's vs a buried TTH prop.
83 V-King, 96 Mariner, 200 hp ff block 2.5 w/a 28p choppa
We gotta clean this liberal mess up, VOTE TRUMP TO MAGA!
Rebuild thread:
http://www.screamandfly.com/showthre...-it&highlight=
http://www.screamandfly.com/showthre...cs.&highlight=
Videos
-
phillnjack thanked for this post
Similar Threads
-
3 blade exhaust thru props for 4 inch hub gear case in 28-30 pitch range
By jdgearheadford in forum Props, Setup, and RiggingReplies: 16Last Post: 07-03-2015, 11:28 AM -
adjust carburetors?
By wittevro in forum Technical DiscussionReplies: 11Last Post: 01-06-2012, 05:07 AM -
Idle adjust????
By Blown Up in forum Technical DiscussionReplies: 6Last Post: 06-01-2010, 08:26 PM -
How to adjust Holley Red?
By B.Mac in forum Technical DiscussionReplies: 27Last Post: 09-21-2003, 06:32 PM