User Tag List
Thanks: 0
Results 16 to 18 of 18
Thread: Initial set up for a Vulture
-
08-23-2017, 01:11 PM #16
sorry about that I was calling my boat a piece of crap not yours.
-
08-28-2017, 05:02 PM #17
I have a nice 24 Raker I'd sell you. I ran a Raker on my 150 omc powered Vector, lots of bow lift.
18 Action 225 Promax
-
08-28-2017, 08:21 PM #18
Buy a low water pickup and save yourself time and money, for something your going to change in the near future. The prop that runs best with the motor buried will more than likely suck when you Jack it up to go fast. Just run any prop you have if you just need to get on the water.
Similar Threads
-
Dw 28 initial test results
By JPEROG in forum General Boating DiscussionReplies: 56Last Post: 05-10-2018, 09:17 AM -
initial timming ...im at about 4-5 BTDC
By bcrector in forum Technical DiscussionReplies: 2Last Post: 07-05-2010, 10:59 PM -
Hydrostream HST initial set up with 260 or 280 2.5 EFI - Right prop & setback?
By RikkiRocket in forum Props, Setup, and RiggingReplies: 6Last Post: 10-14-2008, 09:25 AM -
Initial timing OMC Crossflow
By Lockjaw in forum Technical DiscussionReplies: 2Last Post: 02-05-2006, 10:29 AM -
2.4 EFI BP Initial Timing
By Carter Powell in forum Technical DiscussionReplies: 3Last Post: 06-19-2003, 06:25 PM