User Tag List
Thanks: 0
Likes: 0
Results 1 to 1 of 1
Thread: Avance 22' Prop Question
-
08-02-2017, 09:19 AM #1Junior Member
- Join Date
- Jul 2017
- Location
- VA
- Posts
- 5
- Thanks (Given)
- 0
- Thanks (Received)
- 1
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Avance 22' Prop Question
Hi all, I have an "04 Avance 22' with a 250 Mercury EFI that I am going to replace the lower unit on. The old lower was a torque master with the 1" shaft and I am replacing it with a torque master with the fat shaft so I am either going to have to rehub the Mirage prop I have or just get a whole new setup (which is the way I am leaning). I am running a 20" lower with an Armstrong bracket, I think 22", and trim tabs at the rear. Right now the 23 Mirage, not M+, gets me out of the hole with no problems however my top end at 5700 RPM is only about 53-54 MPH. The only mods to the prop is that I ported it. I do get some ventilating during a hard turn or when I am at the coast going over a wave.
I know there are a few folks that were on here that had an Avance 22 but, so far I can nail down what prop they were running. I think one was running a 25" and went to a 27" on a Yamaha and I have seen another site someone running mid 60's with a Merc and 21" prop but couldn't tell which one. I usually run with a Yeti 110, 100 lbs, in front of the console with 2 people, 450 LBS, fishing gear, 150 LBS, and a 27 gal livewell between the front seats, 250 LBS and 3 batteries in the console. If there is any other information I should be providing, please let me know.
Any help with prop selection to get me started would be greatly appreciated.
Similar Threads
-
Avance 33 Cabriolet
By Avance33 in forum Hulls larger than 20'Replies: 10Last Post: 04-18-2016, 01:50 PM -
Avance 33
By Avance33 in forum General Boating DiscussionReplies: 30Last Post: 07-22-2013, 10:41 AM -
Avance Boats???
By skatermike24 in forum General Boating DiscussionReplies: 3Last Post: 11-30-2009, 09:14 PM -
22' Avance prop HELP...
By ivan2214 in forum Props, Setup, and RiggingReplies: 2Last Post: 10-28-2009, 10:25 PM