WTT: 2007 Custom Built Pro Street Chopper

[Vamp]

Wanting to trade my Pro Street Chopper built in 2006 and registered in 2007 for a 20' or less Mercury powered race/speed hulled boat. Email captrivers@hotmail.com or 225-290-0560 for more info and any interest.

Kraft Tech “Dagger Rigid” 250mm frame 38 degrees of rake 2” downtube stretch 5” backbone stretch
Big-Un chrome front-end assembly 4” over stock
5” stretch aluminum pro street gas tank
60 spoke 21” x 2.15” front wheel
Avon Venom 90/90H-21” front tire
Rear 11” Wild Card one-piece fender
Pro-One rear fender strut
60 spoke 18” x 8.5” rear wheel
Avon Venom 250/40VR-18” rear tire
S&S 103” Sidewinder with less than 500miles on +.10 over bore, NEW pistons and rings, the rings are still cutting-into the cylinders.
Recent install of a Dynatek D2KI-5P Kit (2Ki ignition & DC6-5 Twin Fire II Coil)
ForceWinder air filter
JIMS Oil Pump
JIMS Tappets
JIMS Tappet Blocks
JIMS Gear case Cover
JIMS Roller Rockers
Exotic Choppers DECEIVER pipes
Arlen Ness 5 ¾” stretched bullet headlight
Danny Gray alligator custom wrapped seat
Choppers Inc WHISKY bars
Choppers Inc risers
Choppers Inc oil plug
Pro One RH mirror
Jay Brake front caliper & mounting bracket
Jay Brake front master cylinder
Jay Brake forward controls & passenger pegs
Jay brake rear caliper and bracket
Jay brake clutch lever and grips
BDL belt drive BDL 32T trans pulley and BDL 70T rear pulley

Break-in miles only on:
Bored cylinders .010 and installed S&S pistons and rings
Custom Chrome 5 speed tranny - installed a Baker anti-over shift ratchet pawl, shift arm seal, trans shaft seal and engine main shaft seal with Bel-Ray Big Twin trans fluid 75w-140

[rock]

Sent you a pm.

Rock