User Tag List
Thanks: 0
Likes: 0
Results 1 to 6 of 6
Thread: 21 ft Seebold Porpoising
-
05-23-2017, 07:07 PM #1Member
- Join Date
- Jul 2016
- Location
- Muskoka, Ontario
- Posts
- 48
- Thanks (Given)
- 2
- Thanks (Received)
- 1
- Likes (Given)
- 0
- Likes (Received)
- 7
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
21 ft Seebold Porpoising
Finally got my new motor on and got a chance to take the it out.
1 issue: When I get up to speed the boat start porpoising until I trim down. When I trim down there is not near enough bow lift.
Could this be an engine height issue? I didn't try playing with the engine height yet but thought I'd get some opinions.
The motor is a new 2.5 200 efi with a 26 chopper.
-
06-22-2017, 05:39 PM #2
I have an eagle I run mine 1.5 above the bottom it will bounce around 60, it goes away with more speed. I don't think the hull starts flying at that speed.
-
06-23-2017, 12:17 PM #3Member
- Join Date
- Jul 2016
- Location
- Muskoka, Ontario
- Posts
- 48
- Thanks (Given)
- 2
- Thanks (Received)
- 1
- Likes (Given)
- 0
- Likes (Received)
- 7
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
-
06-23-2017, 04:41 PM #4
A hydraulic plate is nice for that as you can lower the motor a little when it's calm etc and get a little more lift.
1993 Cougar 21ft MTR Superbender SHO
-
06-30-2017, 09:20 AM #5
Sweet set up. Lots of tunnels have a porpoise speed, engine height can be a factor but often just trim it down or power through.
-
02-05-2018, 02:06 AM #6Banned
- Join Date
- May 2016
- Location
- Bean Station Tn.
- Posts
- 314
- Thanks (Given)
- 53
- Thanks (Received)
- 10
- Likes (Given)
- 65
- Likes (Received)
- 50
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
What set up ended up working the best for you
Similar Threads
-
Porpoising
By mbrien in forum Props, Setup, and RiggingReplies: 3Last Post: 03-14-2011, 09:22 AM -
Porpoising
By 2009z in forum Technical DiscussionReplies: 14Last Post: 11-16-2010, 10:27 PM -
Porpoising?
By NFA Avance 33 in forum Props, Setup, and RiggingReplies: 1Last Post: 09-21-2005, 11:08 PM -
Porpoising
By NFA Avance 33 in forum Technical DiscussionReplies: 6Last Post: 09-09-2005, 11:02 AM