24 skater 15 inch motors

[Risco]

Anyone have any pictures of there 24 skater with 15 inch motors looking for pictures of transom area please? Also does any know the part number or have link to offshore clamp ram bushings and through bolt that goes threw the swivel and ram? Here a picture of my progress so far I'm currently 2 inches lower than the previous 20inch 280s have a few ways to get 3 more inches. Trying to be in water in 2 weeks.

[noli]

.


please keep us posted with pics of your awesome Skater!






.

[Sea2jet]

Here are a couple of pictures of my 24 with 15" Simon motors. You can look in my photo album to see more pictures.

[mercracer2.5]

[mercracer2.5]

A lot of time, thinking, and customization went into converting to 15" motors.
Big thanks to Mario at IPM for the great ideas and work

[Speed Jr.]

Your more than likely going to have to machine down the jackplates. My 28 came w/ 15" 280's and the CMC Jackplates were machined down a lot especially the side that had the side rams. Are you doing side mounted rams or front mounted? There probably won't be clearance with the front mounted rams. Boat looks awesome!

Jr.

[toyomirage02]

There isnt a bolt its like a roll pin that has a flat top on it fronm goin in to far

[baja200merk]

Front mount rams are not an option with stock transom unless you have 8" plates. Transom pickups and 15.5" 36 herrings you should only have to go down 2.5" from where 280s were

http://www.screamandfly.com/attachme...4&d=1431038004

[Risco]

Thank you so much thats exactly what I needed I have almost the same jack plates also. Did you notice a difference going from 20s to 15s?

[Risco]

There isnt a bolt its like a roll pin that has a flat top on it fronm goin in to far

My 280 clamps had bolts through them no spot for roll pin

[Risco]

Front mount rams are not an option with stock transom unless you have 8" plates. Transom pickups and 15.5" 36 herrings you should only have to go down 2.5" from where 280s were

http://www.screamandfly.com/attachme...4&d=1431038004

Johnny said he had to go down 1 3/4 from where dago was because of omc tiller arm. You buy the herrings ill run them

[baja200merk]

I thought it was about 1" when I swapped your 21 to a merc clamp I'll measure it. Maybe we should have taken that ~1" off the top of the swivel tube instead of the bottom to drop the arm down.

[Esox4130]

have anymorenpictures of your boat. Love the all white

[Brad Zastrow]

Looks like with 15" mids there is not much room to trim the engines up very far.

[RADER]