User Tag List
Thanks: 0
Likes: 0
Results 1 to 4 of 4
-
02-18-2017, 12:05 AM #15000 RPM
- Join Date
- Jun 2011
- Location
- Australia
- Posts
- 128
- Thanks (Given)
- 0
- Thanks (Received)
- 4
- Likes (Given)
- 3
- Likes (Received)
- 23
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Renegade Prop on Mercury small shaft
Hey guys,
I hear of people running the OMC Renegade Props on Mercury engines.
I have a standard small shaft 3.0L gearbox and want to trial a 25" Renegade prop but it has no provision to positively lock it onto the shaft (requires split pin). What is everyone doing, modifying the prop, or just relying on the Mercury Nyloc nut to hold it on with a plain washer under it? Thanks again
-
02-18-2017, 02:00 AM #2Screaming And Flying!
- Join Date
- Mar 2008
- Location
- Tourist Trap, Florida
- Posts
- 14,753
- Thanks (Given)
- 381
- Thanks (Received)
- 1305
- Likes (Given)
- 5602
- Likes (Received)
- 11033
- Mentioned
- 2 Post(s)
- Tagged
- 1 Thread(s)
Two nuts would be a quick solution. Might have to make one shorter. Looks like you have room though.
83 V-King, 96 Mariner, 200 hp ff block 2.5 w/a 28p choppa
We gotta clean this liberal mess up, VOTE TRUMP TO MAGA!
Rebuild thread:
http://www.screamandfly.com/showthre...-it&highlight=
http://www.screamandfly.com/showthre...cs.&highlight=
Videos
-
02-18-2017, 09:18 AM #3
why not just get a large castellated nut and then drill tiny hole for a split pin ?
then you always have a fail safe even with a merc nut.
I always drilled for a split pin on shafts that did not have them for extra safety, might be over the top but its cheap insurance and
not weakening anything that would be needed.
just a thought.
.
-
02-18-2017, 07:50 PM #45000 RPM
- Join Date
- Jun 2011
- Location
- Australia
- Posts
- 128
- Thanks (Given)
- 0
- Thanks (Received)
- 4
- Likes (Given)
- 3
- Likes (Received)
- 23
- Mentioned
- 1 Post(s)
- Tagged
- 0 Thread(s)
Thanks, I think I'll double nut it for today (kind of embarrassed that I didn't think of that!) and look to drill the shaft if I continue to run the prop. thanks again
Similar Threads
-
Looing for a 26* et small shaft mercury prop
By GaryT in forum Propellers WantedReplies: 6Last Post: 09-17-2016, 04:14 PM -
15x32 Mazco prop, mercury small shaft hub, labbed, great shape, counter
By Leebone46 in forum PropellersReplies: 5Last Post: 04-22-2016, 07:57 AM -
Will a small shaft Mercury hub prop fit a 2015 150 HP 4 stroke shaft
By 4Speed in forum Props, Setup, and RiggingReplies: 1Last Post: 05-16-2015, 03:15 PM -
Mercury HD Small Prop shaft
By moomba in forum Misc. Parts and AccessoriesReplies: 8Last Post: 07-31-2014, 06:31 AM