260 digital harness

[outasite]

In need of a nice 260 harness,Let me know what ya got.

[RONNIE]

good luck merc
nla

[outasite]

I hear ya,Someone's got one there not needing just gotta find it.

[Go Time]

Find 2....I need one too.

[RBT]

I have all the parts to make them except the 90 degree injector clips, find them and I'll make a dozen nicer than mercs, all raychem heat shrink and tinned wire

[Ace]

I have all the parts to make them except the 90 degree injector clips, find them and I'll make a dozen nicer than mercs, all raychem heat shrink and tinned wire

Put me down for one if you make some.
Who made them for Mercury,maybe the injector clips could be found there.

[RBT]

I've looked pretty hard for the clips, the rest of the parts(well the plug) is amp

[outasite]

Have been through about ninety pages of EV1 plugs no ninetys yet,I'm guessing they were a Merc contract.Now if we could just find who made the harness for them,there is probley a box or two laying somewhere!

[Go Time]

You would think the injectors and the plugs would be used in other applications. Is the 90 degree entry what makes them unique?

[RBT]

Yes, but they seem to be a unicorn. Been looking for years

[patchesII]

Do they have to be 90 degree clips?

[RBT]

Funny you say that. I can't remember without looking. I feel like it might interfere with the rail

[outasite]

The Bosch 0280150-036 injector was used on early 70s Mercedes and Volvo as OE.It replaced the 024 and the 043. Im working on an alternate,0280150400 with a custom fuel rail.The 400 is the same OHM impedance and flow.It is OE on 84-85 mustang 302 and F150 302.Working on a mockup to check clearences.This setup would use a solid rail,no short hoses.

[Ally101]

hopefully i will have some clips (exact) soon.i went straight to the source

[tux974]

Injector cleaning machines manufacturer?