User Tag List
Thanks: 0
Likes: 0
Results 1 to 4 of 4
-
07-01-2015, 07:22 PM #1
300XS Water Pump - removing gearcase
Dropping the torquemaster gearcase on my 300XS for the first time and its got a pressure sensing line coming out of the front of the case. How do I disconnect it so I can drop the case to change the pump impeller?
-
07-01-2015, 07:26 PM #2
You will see a little black lip on the fitting. Press it down and pull the hose out. Its a small compression fitting for the speedo.
-
07-01-2015, 07:30 PM #3
Thank you so much! Anything else I should know when putting it back together? Was planning to just replace the impeller and base gasket since the motor only has 37 hours on it.
-
07-01-2015, 07:33 PM #4
nah pretty straight forward if youve done a merc lower before. Turn drive shaft clock wise while pushing down on the water pump housing to seat the impeller. I like to put two allen wrenches in the the opposite corners of the water pump housing to keep the gaskets wear plate and housing in line while I turn the drive shaft and push down on the housing.
Similar Threads
-
OMC Tech: Removing VRO Pump
By HydraSport179V in forum Technical DiscussionReplies: 9Last Post: 06-22-2011, 02:39 AM -
removing sport master off of 300xs
By bohemian609 in forum Technical DiscussionReplies: 2Last Post: 05-25-2010, 07:00 PM -
OMC Tech: removing gearcase
By MTOLLEY in forum Technical DiscussionReplies: 2Last Post: 04-06-2010, 05:01 AM -
A FEW ???? about removing the oil pump
By Jerry Millington in forum Technical DiscussionReplies: 4Last Post: 06-30-2001, 06:21 PM