WTB 93/95 3.0 OMC block

[Jim_Pat]

Want to buy 93/95 Johnson/Evenrude block & front half. Must be salt water free or very little damage and clean up at .030. Please PM with what you have.

[M.CHAPMAN]

I have 2 blocks and front halves here.

One is a 94' 200 Venom block that has a fairly deep scratch in one cylinder due to a locating pin backing out of piston. It may need a sleeve to correct it. I'll have to check the holes to see if they are all standard or if some have been bored over.

One is a 99' 225 HO block that has one damaged cylinder due to lean condition and has one sleeve that has turned in the bore a few degrees. As far as I know on this one all bores are standard. I have the complete powerhead here for it..all electrical and fuel system etc. etc. ...

If either one will work for you let me know and I'll look at them a little further and get back to you .

-Michael 803-897-3806

[deCler]

I have a complete 1996 225hp 25" (OceanPro maybe) motor that needs a rebuild. It's locked up. XP200 cowling.

[Jim_Pat]

I have 2 blocks and front halves here.

One is a 94' 200 Venom block that has a fairly deep scratch in one cylinder due to a locating pin backing out of piston. It may need a sleeve to correct it. I'll have to check the holes to see if they are all standard or if some have been bored over.

One is a 99' 225 HO block that has one damaged cylinder due to lean condition and has one sleeve that has turned in the bore a few degrees. As far as I know on this one all bores are standard. I have the complete powerhead here for it..all electrical and fuel system etc. etc. ...

If either one will work for you let me know and I'll look at them a little further and get back to you .

-Michael 803-897-3806

Thanks Michael but I located a bare block in Michigan this past week.

[Jim_Pat]

I have a complete 1996 225hp 25" (OceanPro maybe) motor that needs a rebuild. It's locked up. XP200 cowling.

Thanks deCler but I located a bare block in Michigan this past week.