1989 Virage Stage 1 Complete and restored

**crankbearing** · 10-01-2014, 09:04 AM

Decided I my 1989 Stage 1 Virage if you have followed the history since I got the boat it has been in the water about 10 times in the last 5 years. It got rebuilt this spring by Ronny's Marine in Havelock same guys doing my Talon for me. The list is as follows but I am sure I am forgetting a couple things:

New Transom, bulkhead with Knees added
Gas Tank in Center Floor Now
New Floor
New Carpet, Todd Seating and Hardware
All New Livorsi GPS, Tach, Volt, Fuel, Trim, Temp,
Hydraulics Steering Seastar Pro 2.0 Helm, 5345 Cylinder
10" Bob's Plate with gauge pump in boat
Turn Signals trim and plate
Hidden Cleats plumbed to bilge for drainage
New Spargi Wheel
24M7 Deka Battery
All New Wiring
New Bilge 750 Auto
Lowrance HDS-5 with Nmea 2000 engine management
Mercury Harness with Smartcraft Gateway and Junction Box
2002 Mercury 200HP with 60 Hours
Alien Cowl with Custom Decals
Fresh 1.87 Sporty with NEW fatshaft propshaft 550$ alone new seals and all new bearings
Racor Air/Fuel Separator
Water Separator
New Sunbrella Black Tonneau Cover

18K OBO I have spent way more than this more in the package to date, pictures can be seen here at this link;

http://www.kijiji.ca/v-view-details....Activated=true

**albypine** · 10-01-2014, 09:15 AM

Nice looking Virage. How does it run with the 200 and 10 inch of set back ?

**crankbearing** · 10-01-2014, 09:45 AM

Thanks alby, The rev limiter on the 200 is 5950, Just under 80 at 5600 with a 30 performance dr4 with more to go a 30 et would have been a better choice with better numbers

**crankbearing** · 10-03-2014, 05:19 PM

Well I sold the motor today so I am not sure what I will do. I have a 260 offshore I can put on it but it's so nice with the 02 200. A 225X would be perfect. I have to pull the motor tomorrow I might put the 250xs on it and go for a blast to see how that works out.

**crankbearing** · 10-08-2014, 07:23 AM

Will sell the Virage without power completely rigged without the smartcraft gateway, junction block and can cable. $7500 with trailer.

**crankbearing** · 10-23-2014, 10:26 AM

Here is a ton of pics I took for an interested person but still for sale. Mike clear your pm's I tried to reply but no go. With the new rigging, gauges, harness and wiring, interior, carpet etc I have in it almost what I am asking for the boat not including the new paint or transom.

http://s759.photobucket.com/user/cra...ge%20Stage%201

Thanks,

Dave