Propeller Suggestions

[mragu]

Bought a 31 Chris Craft Center Console. Model 313 Stinger. Has 200HP 2 Stroke Yamahas. Existing props are 13-3/4x19 ss but hubs are spun so I cannot test. Any suggestions or experience with this hull? Thanks, Ragu

[Frank Molé]

Bought a 31 Chris Craft Center Console. Model 313 Stinger. Has 200HP 2 Stroke Yamahas. Existing props are 13-3/4x19 ss but hubs are spun so I cannot test. Any suggestions or experience with this hull? Thanks, Ragu

rehub and test,let me know when your ready,i didn't get a pic..of that one..................

[hoser]

I no I no
you need double lab Et's

[mragu]

I no I no
you need double lab Et's

Well I know you don't need a 24" chopper cause you don't own a viper

[mragu]

rehub and test,let me know when your ready,i didn't get a pic..of that one..................

Can only rehub one. Props are both right hand and one of the motors is counter rotating. What do you expect, its the "hood"

[native2]

Try some 22 Bravos....

[Mr. Demeanor]

Click the link below. Right up your alley.

http://shop.coolwaterproducts.com/Propeller-Testing-Service_c25.htm

[vnemous]

Click the link below. Right up your alley.

You missed the part where he lives in Long Island.

[Mr. Demeanor]

You missed the part where he lives in Long Island.

Location not an issue. Test prop are shipped out and beats the hell out of the the "buy - test - sell" game.

Now about your self portrait in your sig. You have a small hose and bad aim

[josh7_78]

Mercury Enertia's are my vote. Not sure where it runs so couldn't recommend a pitch, but I know the Enertia's have some serious blade area for moving larger rigs.

[vnemous]

Oh I thought it read that they were mobile and only worked in a certain area in Florida.

[mragu]

so I can use a mercury prop (as long as it has a flo torque hub) on a Yamaha motor with the removable hub kit?

[Mr. Demeanor]

so I can use a mercury prop (as long as it has a flo torque hub) on a Yamaha motor with the removable hub kit?

Yes, I run Merc props on my V4 Yamaha. Even without a flotorque hub, the shaft and splines are the same. You just need the correct thrust washer. Gove Ken a call, he will get you squared away. He has thousands of boat/motor combos he has already worked with and probably already set up that boat/engine combo. There is also a forum on his website where you can ask.

[mragu]

Yes, I run Merc props on my V4 Yamaha. Even without a flotorque hub, the shaft and splines are the same. You just need the correct thrust washer. Gove Ken a call, he will get you squared away. He has thousands of boat/motor combos he has already worked with and probably already set up that boat/engine combo. There is also a forum on his website where you can ask.

Thank you for the help! I will give him a call tomorrow,

[Dirk Pitt]

nice mike