User Tag List
Thanks: 0
Likes: 0
Results 1 to 15 of 63
Thread: Tunnel hull hydroplane
Threaded View
-
11-26-2012, 11:02 AM #11
If this were mine I would finish the boat using CPES http://www.jamestowndistributors.com..._1269&type=pla according to the instructions.
Spray a epoxy primer surfacer such as: http://www.eastwood.com/ew-4-1-ureth...RCCODE=1SE0757
Then block and spray with a single stage acrylic urethane such as: http://www.eastwood.com/ew-69-72-gm-...thane-kit.html
The West Epoxy by itself on this wood boat isn't going to do anything but make a lot more work for you and probably make a lesser finished job long term. West if perfect for repairs but it's not the best to use as a coating, used by itself.
But then again, these are just my thoughts.
Last edited by Bruster; 11-26-2012 at 12:49 PM.
Bruster's Mercury solid motor mounts, details here:
http://www.powercatboat.com/Bruster/Bruster.htmlI'm been living in fast forward, now I need to rewind real slow....