I have decided to put my 250 xs up for sale.
I had hopes up finding a boat big enough to mount it to but I have had no such luck around here. I would rather see it get used than sit in my garage.
It ate #6 piston right after I bought it and I decieded to rebuild it still hoping to find a boat to put it on.
I had Jim Ruck push a new sleve in and deck the block.
Used rod, New Rod bearings, New rod bolts, New piston, All new rings, All new gaskets, Injectors were cleaned, New spark plugs
Torque Master gear case with LWP
It has a 25 inch shaft.
480 ish hrs on every thing but only 5 or so on rebuilt power head
The trim pump is included with the motor
I put it on my brothers Pro Craft just so I could run it and break it in. It has scary ammounts of power and runs very well.
Hey jeepster. Is this this engine RH rotation. What is the RPM range on this motor.
Where are you located and what is the cost to ship to 07440 (Pequannock, NJ)
How clean is the engine. Leave number so I can call you. Is the motor still available!
Email me at firstname.lastname@example.org
Thanks, Jimmy Hosier