I have a DCB Mach 22 with dual 2.5 Mercs hanging off of the back. When screaming along then getting off of the throttle the boat gets real squirly. I noticed that I can push the motors back and forth about 3-4 inches side to side without the steering wheel moving at all. Also when I turn the wheel it rotates about 180 degrees before teh motors move. OUCH!!!

How do I go about bleeding the air out of the hydraulic system from both motors while keeping the alignment of the steering wheel and the motors in the center of there travel. This is a manual (no electric motor) hydraulic system with two cylinders, one on each motor.

Trying to get her out today but would like to also be alive at the end of the day. Thanks JG