Results 1 to 10 of 10
09-13-2009, 07:39 PM #1
Simple Sportmaster flush cup idea...
12-16-2010, 08:30 PM #2
Cool. I'll have to try this.
12-16-2010, 08:58 PM #3
A 2 litre soda bottle cut and slit with a bungie works great too. A hose will screw right on to it.
12-16-2010, 09:32 PM #4
ok,but ive tried them all ,from factory type exact fit ,expensive the glove, to the cheepo adaptors & the very best is the noodle type for sporty or cle, they cost about $2 to $3 to make & even show a small amount of pressure on the water pressure gage when flushing.which none of the muffs or high$$ do on any lu.
12-16-2010, 09:58 PM #5
12-16-2010, 10:30 PM #6
Mr Slagle, could describe how to construct the noodle style flusher you mentioned. Thank You. PH
12-16-2010, 10:53 PM #7
I built mine using (1) female garden hose end, (2) 6-inch pieces of tubing (my modified sporty has two intakes...you might need a different number of pieces of tubing due to the number of intakes), and some epoxy.
Simply stick the ends of the pieces of tubing into the female hose end epoxy them into place, taking care not to get the epoxy into end of the tubing. Give the epoxy time to set, and you're done.
12-16-2010, 11:04 PM #8
H2o, so ya just jam the tubes into the lower and turn on the water? The tubes don't pop right off?
Sounds easy and cheap to make! PH
12-16-2010, 11:06 PM #9
Yep...just jam 'em right up in there. They hang in there just great!
12-16-2010, 11:09 PM #10
I'll give it a whirl. Thanks