User Tag List
Thanks: 0
Likes: 0
Results 1 to 15 of 16
Thread: Piston/cylinder wall clearance
Threaded View
-
05-24-2009, 03:22 PM #15000 RPM
- Join Date
- May 2009
- Location
- West Virginia
- Posts
- 102
- Thanks (Given)
- 0
- Thanks (Received)
- 0
- Likes (Given)
- 0
- Likes (Received)
- 0
- Mentioned
- 0 Post(s)
- Tagged
- 0 Thread(s)
Piston/cylinder wall clearance
Recently had a "new" powerhead put on my Merc 2001/225HP/EFI. Have had problems getting out of the hole and general sluggishness, since this installation. I am going to put a set of Simon worked heads, new reeds, and a reworked flywheel from Eric Simon. Tore it down to install above and checked clearance between piston and cylinder wall. All were .45mm, and seemed to me, "a real novice" that the pistons were rather loose, but I don't know. I do know there has to be some expansion clearance, but is this .45mm within tolerance?
Last edited by Powmer; 05-24-2009 at 03:24 PM. Reason: more info