Hi,
Bought an Exocet 23 (piranha hull with phantom deck) and I put a 300 R, 1.75 TM, on it (not an SM, no hydraulic jackplate on it).
Is the gasket between carb and intake supposed to cover this hole in pic #1? In Pic #2 the the mixture screw is at the other end and in the middle there
Last Post By: Ron C. Today, 06:18 PMHey -
Im looking for the 5” midsection/driveshaft extension for a 3.0 liter Merc
Hoping someone has one stashed
Thanks!
Try to figure out why my 200hp merc is overheating, This is the second powerhead and both seem to do the same thing, I got a better run today with the
Last Post By: Aaronhl Today, 05:45 PMI have a 2nd hand Brucato 3.0L promax slide front forsale $1000.00 ono
Thanks
Rick
2011 stv euroski (full throttle)
pristine condition
orginal 2.5l efi 280 ros never been rebuilt very low original hours
ecu tunned
Evinrude outboard Motor 175 HP Runs great.
V6 2 stroke 25 inch shaft. Shifts good.
Power trim and tilt works good.
Runs on Premix. VRO
I,m looking for parts Yamato Model 80
Can anyone help ?
Hey guys I’m looking for some oversized pistons to rebuild a pair of Suzuki DF 150 4t engines and came up empty on eBay. Was wondering if anyone knows
Last Post By: pcrussell50 Today, 02:38 PMI laugh every time I see this.
I have several Mercury Optimax outboards available:
One (1) freshly rebuilt 250XS Gold Block (20") w/TM @ $9000
One (1) freshly rebuilt
Post a random photo thread! Add yours!
Post a random pic Thread i will Start Freeze Frame
Add yours
other forum has one of these
What are the pros and cons of foam decking, like SeaDek, for a performance river boat? Is it heavier than carpet?
Thanks in advance.
Pantera new builds
Thread Starter: noli.
Last Post By: David Today, 06:55 PMPantera building a plug from an original 24 footer