Can you run surface gap spark plugs with the CDM ignition or do you have to use switch boxes?
Does the efi (tbi) fuel system need to run
1995 Brad Collins Mirage, Boat and trailer only . Just needs motor.
Call or text for more pictures & info.
Sean 305-975-4224
.
Rey Marino (may he rest in peace) would be very proud right about now to see his work become a world record holder
Does anyone have a source for the rubber grommets that go on the pink tip injectors(260/ F1, Drag) that the hold down fits over. I found some but they
Last Post By: largecar91 Today, 03:38 PMI laugh every time I see this.
Looking for a small chopper prop for a 2cyl omc 13 spline . Ty
Last Post By: evinrudejohnson Today, 02:29 PMStarting this post to see how many of these are still out there. Whether you or a current or past owner, please post pics and any info about the boat.
Last Post By: PurpleHaze94 Today, 02:15 PMSportmaster Lover Unit 15” shaft. (This is a siezed LU) Haven’t pulled it apart. But case is in good shape. Could use for parts possibly. 1500$ obo. PM
Last Post By: aj06bolt12r Today, 02:13 PMI know he had some friends on here,but he passed away yesterday I’ll be going down by him this week to help his wife out
Last Post By: VkingMike Today, 01:54 PMI am turning 70, so it's time to smell the roses, I haven't owned an inboard since the 70's,
But these old Sea Ray's from the 1980's are
These were brand new not rebuilt , Mercury 300xs motors DBR stage 2 kits, low hours under 75hrs each, 300x mids 20", lowers rebuilt with all the
Last Post By: RPMsRUP Today, 10:43 AMHi guys I’m new here. I looking for some info as to where the gas tank should be mounted in a 13 foot fun cat. I’m doing a full restoration have the top
Last Post By: Fun cat 13 Today, 08:44 AMI have a 20ft Pro line with a Mercury 125hp. When I transport it to the boat ramp I tilt my Mercury up. The 2 stroke oil leaks out of the oil resovoir
Last Post By: gerrydi69 Today, 08:40 AMxst 18. i pulled one bad spot up in the floor and now it looks like i have to redo the center bilge area of the hull itself. and if this boat was built
Last Post By: KIRCHNER Today, 07:29 AM
Message